Heat-controller DMH24DB-1 Manual de usuario descargar pdf (Pagina 30)

30 Multi type Air Conditioner

Checking the Drainage, Forming the Pipings and Long Pipe Setting

Forming the piping

Form the piping by wrapping the con-

necting portion of the indoor unit with

insulation material and secure it with

two kinds of vinyl tape.

• If you want to connect an additional drain hose, the end

of the drain outlet should be routed above the ground.

Secure the drain hose appropriately.

In cases where the outdoor unit is

installed below the indoor unit perform

the following.

1. Tape the piping, drain hose and connecting cable from

down to up.

2. Secure the tapped piping along the exterior wall using

saddle or equivalent.

In cases where the Outdoor unit is

installed above the Indoor unit perform

the following.

1. Tape the piping and connecting cable from down to up.

2. Secure the taped piping along the exterior wall. Form a

trap to prevent water entering the room.

3. Fix the piping onto the wall by saddle or equivalent.

Seal a small opening

around the pipings

with gum type sealer.

Trap

• Trap is required to prevent water from entering

into electrical parts.

Plastic

band

Taping

Drain hose

Pipings

Connecting

cable

Power supply

cord

Seal a small

opening around

the pipings with

gum type sealer.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35

Comentarios a estos manuales

Sin comentarios

Heat-controller DMH24DB-1 Manual de usuario Pagina 30

Comentarios a estos manuales

Relacionado con productos y manuales para Acondicionadores Heat-controller DMH24DB-1